Abstract
In this work, Abrasive Water Jet Machining (AWJM) on aluminum based hybrid composite with Silicon Carbide (SiC) and Boron Carbide (B4C) reinforcement particles are investigated. Two different abrasive grain sizes of 80 mesh and 120 mesh are selected to carry out the experiments. The cutting parameters namely pressure, standoff distance (SOD) and traverse speed are assessed in terms of the kerf angle, Material Removal Rate (MRR) and Surface Roughness (Ra). The result shows that the coarse abrasive particle has a favorable effect on the MRR, while the fine grained abrasive particle produced minimum kerf angle and good surface finish.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
