Effect of a novel cold atmospheric plasma jet treatment with different temperatures on resin-dentin bonding

Abstract

To investigate the effect of different treatment temperatures of a novel cold atmospheric plasma jet treatment on the resin-dentin bonding. (1) Fifty-two freshly extracted, non-carious and intact third molars were collected. The occlusal one-third of the crown was removed by means of a water-cooled low-speed Isomet saw. One dentin disc [(900 ±100) μm] was prepared for each tooth. The fifty-two dentin discs were randomly divided into control group and experimental groups, of which four were in control group, and forty-eight were divided into four experimental groups according to the different treatment temperatures (4 °C, 10 °C, 20 °C and 30 °C) of the novel radio-frequency atmospheric-pressure glow discharge (RF-APGD) plasma jet, twelve in each group. Each experimental group was divided into three subgroups according to different treatment time (10 s, 20 s and 30 s), with four in each subgroup. The occlusal one-third of the crown was removed by means of a water-cooled low-speed Isomet saw. The morphology of demineralized dentin surfaces was analyzed using field emission scanning electron microscopy. (2) Twenty unerupted, non-carious and intact third molars were randomly divided into five groups, four in each group: control group, untreated; 4 °C, 10 °C, 20 °C and 30 °C experimental groups, each group was treated with the RF-APGD plasma jet for 20 s. The micro-tensile resin dentin bond strength was tested after 20 s RF-APGD plasma jet treatment with different temperatures, using a universal mechanical machine. (1) The field emission scanning electron microscopy results indicated that when compared with the control group, a 10 s RF-APGD plasma jet treatment with 30 °C and 20 °C collapsed the collagen scaffold. Collagen fibrils maintained an uncollapsed three-dimensional structure after the 4 °C RF-APGD plasma jet treatment for even 30 s treatment. (2) The microtensile resin dentin bond strength results of the 4 °C RF-APGD plasma jet treatment group (57.8±0.7) MPa were significantly higher than that of the control group [(47.4±0.5) MPa] and 10 s, 20 s and 30 s RF-APGD plasma treatment group [(51.9±0.7) MPa,(29.7±1.0) MPa and (22.2±1.5) MPa] with statistically significant difference (P<0.05). Compared with the control group, the micro-tensile bond strength increased about 21.9% and 9.5% after 4 °C and 10 °C RF-APGD plasma jet treatment, respectively. Compared with other treatment temperatures, this novel RF-APGD plasma jet treatment with the temperature of 4 °C can preserve the three-dimensional morphology of demineralized dentin better, and can improve the resin-dentin bonding.