Abstract
The dynamic modeling and simulation based on components for parallel type and series type absorption refrigeration using novel working pairs [mmim]DMP/CH3OH were conducted. The modified UNIFAC model and Wilson model were used to describe the vapor liquid equilibrium and excess enthalpy of the [mmim]DMP/CH3OH solution, respectively. Under certain assumptions, the dynamic model was developed including the HPG (high pressure generator) model, the LPG (low pressure generator)-condenser model, the absorber-evaporator model and the SHX (solution heat exchanger) model. The effect of exhaust gas inlet temperature and chilled water inlet temperature on the thermodynamic performances were presented and discussed. The best COP of 1.27 and 1.17 for parallel type and series type system, respectively, were observed. The transient responses at step changes of two variables and on experimental conditions were carried out and analyzed, and the latter had been compared with the experimental data in literature. It is indicated that the model well describes the stable and transient characteristics of the double effect absorption refrigeration using [mmim]DMP/CH3OH, and can be employed to enable the further parameter optimization and control design.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
