Abstract
Cubic shaped specimens with different angles between layer orientation and loading surface were tested quasistatically and dynamically. We found, that shear strength is slightly dependent on the compression load when the angle between layer orientation and load direction is in the range 30-60 degrees and increases 2 times at the angle 750. Material is strain rate sensitive but the behavior of the shear strength is the same at the high strain rates. transversal direction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
