Ductility Variation and Improvement of Strain-Hardening Cementitious Composites in Structural Utilization.

Abstract

Strain-hardening cementitious composite (SHCC) has the obvious advantages of excellent material properties such as its high tensile and compressive strengths, high tensile strain capacity, and excellent durability against multi-cracking performance with very fine crack widths. In particular, the multi-cracking performance of SHCC during structural utilization is obviously reduced compared to that of SHCC in uniaxial tension tests using dumbbell-shaped specimens of small size. The corresponding tensile strain capacity of SHCC during structural utilization is, thus, significantly decreased compared to that of SHCC in uniaxial tension tests. However, the reduction in the ductility of SHCC during structural utilization has not been sufficiently understood, and further study is required. This paper presents an experimental investigation into the ductility variation of flexural-failed and shear-failed SHCC members as well as the ductility improvement of SHCC members with steel reinforcement compared with that of SHCC in uniaxial tension tests using small-sized specimens. This study focuses on not only the decrease in the crack elongation performance of the SHCC material during structural utilization but also the increase in the crack elongation performance of SHCC members with steel reinforcement. The results demonstrate that the crack elongation performance of flexural-failed and shear-failed SHCC members is significantly reduced compared to that of SHCC in the uniaxial tension tests. Moreover, it was confirmed that steel reinforcement can effectively improve the SHCC member, increasing the strain-hardening capacity and multi-cracking performance. The load-carrying capacity of the flexural-failed SHCC member with steel reinforcement seemed to increase linearly with an increase in the reinforcement ratio, accompanied by an increase in the distribution of multiple fine cracks in the flexural-failed SHCC member with steel reinforcement.