Abstract
To match the increasing miniaturization and integration of electronic devices, higher requirements are put on the dielectric and thermal properties of the dielectrics to overcome the problems of delayed signal transmission and heat accumulation. Here, a 3D porous thermal conductivity network is successfully constructed inside the polyimide (PI) matrix by the combination of ionic liquids (IL) and calcium fluoride (CaF2 ) nanofillers, motivated by the bubble-hole forming orientation force. Benefiting from the 3D thermal network formed by IL as a porogenic template and "crystal-like phase" structures induced by CaF2 - polyamide acid charge transfer, IL-10 vol% CaF2 /PI porous film exhibits a low permittivity of 2.14 and a thermal conductivity of 7.22 W m-1 K-1 . This design strategy breaks the bottleneck that low permittivity and high thermal conductivity in microelectronic systems are difficult to be jointly controlled, and provides a feasible solution for the development of intelligent microelectronics.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
