Droplet evaporation and solute precipitation during spray pyrolysis

Abstract

The process of spray pyrolysis was investigated theoretically using a model that describes the evolution of the droplet size, solvent vapor concentration in the carrier gas, and both droplet and gas temperatures along the reactor axis. The model also accounts for solute concentration profiles and solute precipitation in the solution droplets. The model was used to describe the evaporation of sodium chloride aqueous solution droplets in diffusion dryers and hot-wall reactors as a function of reactor residence time, droplet size (a few microns), solution molality (up to 2 M), droplet concentration (10 6–10 7 cm −3), relative humidity of the carrier gas (0–50%) and reactor wall conditions. Decreasing initial droplet size and solution molality accelerated droplet evaporation and resulted in smaller droplets at the onset of solute nucleation. Decreasing droplet concentration and carrier gas inlet relative humidity as well as increasing wall temperature (up to 350°C) or axial wall temperature gradient (up to 100°C cm −1) increased the droplet evaporation rate, but did not change appreciably the droplet size at the point of precipitation for a given droplet size and solute concentration. Thus, control of droplet size at the onset of solute nucleation by varying process parameters other than the solution concentration and initial droplet size is limited.