Abstract
A near-infrared femtosecond laser is focused by a 100 mm-focal-length plano-convex lens to form a laser filament, which is employed to drill holes on copper targets. By shifting or rotating the focusing lens, additional aberration is imposed on the focused laser beam, and significant influence is produced on the aspect ratio and cross-sectional shape of the micro-holes. Experimental results show that when proper aberration is introduced, the copper plate with a thickness of 3 mm can be drilled through with an aspect ratio of 30, while no through-holes can be drilled on 3-mm-thickness copper plates by femtosecond laser with minimized aberration. In addition, when femtosecond laser filament with large astigmatism is used, micro-holes that had a length to width ratio up to 3.3 on the cross-section are obtained. Therefore, the method proposed here can be used to fabricate long oval holes with high aspect ratios.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
