Abstract

A contemporary challenge for the construction industry is to develop a technology based on natural building materials which at the same time provides high energy efficiency. This paper presents the results of an airtightness test and a thermal imaging study of a detached house built with technology using cross laminated dowelled timber panels. The thermal conductivity coefficients of the wood wool used to insulate the walls and ceiling of the building have also been measured, the linear heat transfer coefficients of the structural nodes have been numerically determined, and calculations have been made regarding the energy efficiency of the building. On the basis of the research, it was found that the air exchange rate in the analyzed building n50 is at the level of 4.77 h−1. Air leaks were also observed in the places of connection of longitudinal walls with the roof and at the junction of window frames with external walls. The experimentally determined thermal conductivity coefficient of the wood wool was ~10% higher than that declared by the manufacturer. Calculations for the energy performance certificate showed that an increase of ~10% in the thermal conductivity coefficient of the wood wool used to insulate the building results in a heating demand increase of 2.1%. It was also found that changing the value of the parameter n50 from 1.0 h−1 to 4.77 h−1 leads to a 40.1% increase in heat demand for heating the building. At the same time, the indicators for final energy demand EK and non-renewable primary energy demand EP increase by 18.1%.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call