Abstract

A comparison of gamma-ray dose fractionation effects was made using plateau-phase cultures of C3H 10T1/2 cells and their transformed counterparts in an attempt to simulate basically similar populations of cells that differ primarily in their turnover rates. The status of cell populations with respect to their turnover rates may be an important factor influencing dose fractionation effects in early- and late-responding tissues. In this cell culture system, the rate of cell turnover was approximately three times higher for the plateau-phase transformed cultures. While the single acute dose survival curves for log-phase cells were indistinguishable, there were significant differences between the survival curves for plateau-phase cultures of the two cell types. These differences were qualitatively similar to the differences recently postulated for the survival of target cells governing early and late tissue responses. Both cell lines had a similar capacity for repair of sublethal damage, but untransformed cells had a much greater capacity to repair potentially lethal damage in plateau phase. Further, untransformed plateau-phase cultures were much more sensitive to a radiation-induced G1 (or G0 to G1) delay than transformed cultures. Multifraction survival curves were determined for both cell lines for doses per fraction ranging from 9.0 to 0.8 Gy, and from these isoeffect curves of log total dose versus dose per fraction were derived. The isoeffect curve for the slowly cycling, untransformed cells was found to be appreciably steeper than that for the more rapidly cycling transformed cells, a finding consistent with previously reported differences in dose fractionation isoeffect curves for early- and late-responding tissues in vivo.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.