Does critical shoulder angle predict abduction motion and acromion-tuberosity impingement in reverse shoulder arthroplasty?

Abstract

BackgroundVirtual planning software for reverse shoulder arthroplasty (RSA) has introduced the ability to optimize implant position in an effort to maximize bony impingement–free motion. Abduction impingement typically occurs between the glenoid and polyethylene or between the tuberosities and the acromion or coracoid. Acromion-tuberosity impingement has been considered less desirable, as it may create additional stress on the acromion. Patients with a large acromion overhang may have higher rates of acromion-tuberosity impingement. As the critical shoulder angle (CSA) represents a larger distance from the glenoid face to the acromion, the purpose of this study was to evaluate the impact of implant selection and position on abduction motion and acromion-tuberosity impingement, with a focus on the association to CSA. We hypothesize that a larger CSA will be associated with less abduction motion and an increase in acromion-tuberosity impingement. MethodsThis is a retrospective cohort case series of 85 consecutive patients who underwent RSA from June 2020 to January 2021. Humeral and glenoid components were implanted virtually (SurgiCase) using a standard protocol for a single implant system (DJO AltiVate Short Stem Reverse) with an inset humeral component. Implant variables analyzed included baseplate location (central vs. inferior glenoid), glenosphere lateralization (10 mm vs. 6 mm), and humeral shell (standard vs. semiconstrained). The maximal degree of abduction and location of impingement were recorded at external rotation of 0°, 45°, and 90°. Implant combinations that resulted in no impingement and no motion were recorded. ResultsIncrease in CSA was associated with acromion-tuberosity impingement for nearly every combination at 0° and 45° external rotation; however, there were no significant associations between CSA and maximum abduction motion. Acromion-tuberosity impingement was associated with central glenosphere placement in all degrees of external rotation (P < .001), use of a 10 mm lateralized glenosphere for 0° (P < .001) and 45° (P = .076), and using a standard polyethylene shell for 0° (P = .032) and 45° external rotation (P = .007). Maximal abduction motion was associated with inferior placement (P < .001), and use of a 10 mm lateralized glenosphere (P < .001) in all positions of external rotation but was not influenced by the polyethylene type. ConclusionIncreased CSA is associated with acromion-tuberosity impingement and can be used to screen for patients at risk for bony impingement in abduction. Placement of the glenosphere centrally and use of a 10 mm lateralized glenosphere were associated with higher rates of acromion-tuberosity impingement. Maximal abduction can be achieved using a 10 mm lateralized glenosphere and inferior placement.