Abstract
We report on a novel application of the layer-by-layer (LbL) assembly technique to attach multiple layers of DNA and poly-l-lysine (PLL) onto preformed lipid-coated microbubbles to increase the DNA loading capacity. We first measured the effects of the cationic lipid fraction and salt concentration on the microbubble stability. Microbubble production and stability were robust up to a cationic lipid fraction of 40 mol % in 10 mM NaCl. DNA adsorption was heterogeneous over the microbubble shell and occurred primarily on the condensed phase domains. The amount of adsorbed DNA, and subsequently adsorbed PLL, increased linearly with the fraction of cationic lipid in the shell. DNA loading was further enhanced by the LbL assembly method to construct polyelectrolyte multilayers (PEMs) of DNA and PLL. PEM buildup was demonstrated by experimental results from zeta potential analysis, fluorescence microscopy, UV spectroscopy, and flow cytometry. The PEMs exhibited two growth stages and were heterogeneously distributed over the microbubble surface. The DNA loading capacity onto the microbubbles was enhanced by over 10-fold by using five paired layers. However, the PEM shell did not prevent oscillation or destruction during ultrasound insonification. These results suggest that the surface can be compartmentalized to make multifunctional, high-payload ultrasound contrast agents for targeted gene therapy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.