Abstract
In this work, the resistance spot welding (RSW) process was performed to join aluminum alloy and low-alloy carbon steel plates. The macro characteristics including nugget diameters and indentation rates, microstructure and tensile-shear strength of RSW joints were investigated. The results showed that the nugget of the RSW joints comprises a ‘bowl’ shape nugget on the aluminum side and an elliptical shape nugget on the steel side. Also, the intermetallic compound (IMC) layers containing Fe4Al13 and Fe2Al5 were formed around the aluminum/steel interface with the steel side having a tongue-shape and the aluminum side having a needle-shape. According to metallurgical evaluation and temperature distribution of RSW joints analyzed by the finite element method, the nugget on the aluminum side contained the dendritic grains and equiaxed dendritic grains. The nugget on the steel side consisted of a large amount of bainite and a small amount of coarse lath martensite. The nugget diameters and the indentations rates of RSW joints increased when increasing either welding current or welding time, and decreased when increasing the electrode pressure. The maximum values of nugget diameter and indentation rate of RSW joints were 9.076 mm and 4.144% when using the welding current of 16 kA, welding time of 450 ms and electrode force of 3 kN. In tensile-shear tests, the RSW joints showed a shear-off fracture mode. When increasing the welding current, welding time or electrode force, the tensile-shear strength of RSW joints increased first, and then reached a maximum, and finally decreased. The welding current of 16 kA, the welding time of 300 ms, and the electrode pressure of 3 kN were considered as the optimal welding parameters in the present study which resulted in the maximum tensile-shear strength of 2.24 kN. In addition, the IMC layers of the RSW joints exhibited a uniform and continuous appearance with a thickness of approximately 1.9 μm, and the IMC layer in the central area was thicker than that in the edge area.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
