Abstract

BackgroundPatients who have spinal stiffness and deformity are at the highest risk for dislocation after total hip arthroplasty (THA). Previous reports of this cohort are limited to antero-lateral and postero-lateral (PL) approaches. We investigated the dislocation rate after direct anterior (DA) and PL approach THA with a contemporary high-risk protocol to optimize stability. MethodsWe investigated patients undergoing THA who had preoperative biplanar imaging from January-December 2019. Patients were identified using radiographic criteria of spinal-stiffness (<10-degree change in sacral slope from standing to seated) and deformity (flatback deformity with >10-degree difference in pelvic incidence and lumbar lordosis). There were 367 patients identified (181 DA, 186 PL). The primary outcome was dislocation rate at 2-years postoperatively. Risk-factors for dislocation were evaluated using logistic regressions (significance level of 0.05). ResultsThere were 6 (1.6%) dislocations in the entire cohort, with low dislocation rates for both DA (0.6%) and PL-THA (2.7%). We observed increased utilization of dual mobility with larger outer head bearings (>38 mm) with PL-THA (34.4 versus 5.0%, P < .01) and conversely increased utilization of 32-mm femoral-heads with DA-THA (39.4 versus 7.0%, P < .001). Surgical approach (PL) was not a significant risk-factor for dislocation (odds ratio: 5.03, P = .15). Patients who had a history of lumbar-fusion had 8-times higher odds for dislocation (OR: 8.20, P = .020). ConclusionsTo the best of our knowledge, this is the largest series to date evaluating DA and PL-THA in the hip-spine 2B-group. Our results demonstrate lower dislocation rate than expected with either surgical approach using a high-risk protocol.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.