Discussions on the Properties of Emulsion Prepared by Using an Amphoteric Chitosan as an Emulsifier

Abstract

A typical emulsion contains oil and water phases, and these two phases can be combined by an emulsifier with both lipophilic and hydrophilic groups to form a mixture. If the component of water is more than oil, the mixture is termed as o/w emulsion. The water is called the continuous phase and the oil is called the dispersed phase. Oppositely, if the component of oil is more than water, the mixture is termed as w/o emulsion. The oil is called the continuous phase and the water is called the dispersed phase. Chitosan, which is biocompatible and non-toxic, was modified as an amphoteric emulsifier to replace sodium acrylates copolymer in the preparation of emulsions. Both sodium acrylates copolymer and the modified chitosan were used as emulsifiers, respectively, and the properties of moisturizing, transmittance, the number of bacteria, and emulsion stability were measured. The experimental results showed that the amount of amphoteric chitosan is less than that of sodium acrylate copolymer by 20% under a similar degree of emulsification. The measurement of spatial moisture showed the difference in equilibrium humidity was in the range of 2.05 to 2.20 gH2O/kg dry air, indicating that the moisture retention of the modified chitosan is better. In addition, the calculation of bacterial growth confirmed that the number of bacteria in the amphoteric chitosan emulsion and the sodium acrylate copolymer emulsion were 80 and 560, respectively. The emulsion stability was tested by the separation of oil and water phases in the diluted emulsion and by centrifugal accelerated sedimentation. The results showed that, for both emulsifiers, no separation of the oil and water phases occurred within one hour, and the stability of the modified chitosan emulsion was better. Therefore, the modified chitosan successfully substitutes sodium acrylates copolymer as an emulsifier in the preparation of emulsion.