Directional heat treatment technique to prepare columnar grains in a TiAl alloy: Microstructure evolution and deformation behavior

Abstract

Directional TiAl alloys show excellent comprehensive mechanical properties at high temperature (HT), and their notable attributes in high-temperature deformation resistance offer them promising application potential as structural materials in the aero engine industry. Directional heat treatment (DHT) is an effective local solid phase transformation technology in alloy processing and microstructure control. The directional Ti47Al2Nb2Cr alloys with columnar grains microstructure were fabricated via multiple DHT technology, where the HT deformation performance and corresponding deformation mechanism were both investigated. Results show that both the length in axial and width in radial are increasing with the increase of DHT time, together with the reduce of columnar grains amount, ultra-large columnar grains of 58.6 mm in length and 4.8 mm in width are even obtained, which makes it possible to realize the directional single crystals fabrication further, and the DHT-TiAl alloy may possess a tensile strength of 611.7 MPa at 800 ℃. For the first time, the mechanism of columnar grain growth is considered from the point of thermodynamics via analyzing the driving force of different DHT regions, which is thought to be greatly related to the temperature gradient, and the rule of preferred orientation choosing for columnar grains growth is discussed as well, then we defined the possible conditions of controlling columnar grains steady growth. Eventually, the detailed deformation mechanism of the multiple-DHT treated TiAl alloy was analyzed by transmission electron microscopy (TEM), which demonstrates that the twin intersections together with stress-induced γ variants within γ matrix, and the well-known long period stacking order (LPSO) structure 6 R and 9 R characterized by periodic stacking fault both found near α2 phase and γ twins/pseudo-twins further improved the plastic deformation accommodation and interface compatibility of DHT-TiAl alloy. This observed microstructure transformation and corresponding mechanical performance improvement demonstrate the potential of DHT technology in microstructure improving and properties strengthening for TiAl alloys during practical manufacturing process.