Abstract
A novel direct polymer-transfer lithography (DPTL) technique is proposed for fabricating fine patterns having feature sizes ranging from ten to several tens of micrometers with extremely high throughput. By means of this technique, a homemade fluorine-containing polymer “ ink”, which has good water repellency, was imprinted directly onto a Cu/polyimide sheet by using an elastomeric polydimethylsiloxane (PDMS) stamp; imprinting was followed by wet etching of the Cu layer, with the transferred polymer patterns serving as an etch mask. Under the optimized imprinting conditions, Cu lead patterns with a minimum line width of approximately 10 μm were successfully fabricated with high accuracy and good reproducibility. The DPTL technique will be very useful for manufacturing flexible printed circuit boards (FPCs).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.