Direct Monitoring of Initiation Factor Dynamics through Formation of 30S and 70S Translation-Initiation Complexes on a Quartz Crystal Microbalance

Abstract

Translation initiation is a dynamic and complicated process requiring the building a 70S initiation complex (70S-IC) composed of a ribosome, mRNA, and an initiator tRNA. During the formation of the 70S-IC, initiation factors (IFs: IF1, IF2, and IF3) interact with a ribosome to form a 30S initiation complex (30S-IC) and a 70S-IC. Although some spectroscopic analyses have been performed, the mechanism of binding and dissociation of IFs remains unclear. Here, we employed a 27 MHz quartz crystal microbalance (QCM) to evaluate the process of bacterial IC formation in translation initiation by following frequency changes (mass changes). IFs (IF1, IF2, and IF3), N-terminally fused to biotin carboxyl carrier protein (bio-BCCP), were immobilized on a Neutravidin-covered QCM plate. By using bio-BCCP-IF2 immobilized to the QCM, three steps of the formation of ribosomal initiation complex could be sequentially observed as simple mass changes in real time: binding of a 30S complex to the immobilized IF2, a recruitment of 50S to the 30S-IC, and formation of the 70S-IC. The kinetic parameters implied that the release of IF2 from the 70S-IC could be the rate-limiting step in translation initiation. The IF3-immobilized QCM revealed that the affinity of IF3 for the 30S complex decreased upon the addition of mRNA and fMet-tRNA(fMet) but did not lead to complete dissociation from the 30S-IC. These results suggest that IF3 binds and stays bound to ICs, and its interaction mode is altered during the formation of 30S-IC and 70S-IC and is finally induced to dissociate from ICs by 50S binding. This methodology demonstrated here is applicable to investigate the role of IFs in translation initiation driven by other pathways.