Abstract
This work presents a combined experimental and numerical study on the fracture toughness behaviour of a ductile epoxy resin system. Quasi-static fracture tests using single edge notched bending (SENB) specimens were conducted under room temperature conditions. In addition, the digital image correlation technique was employed to experimentally map the full-field displacements and strains around the notch and crack tip, allowing direct calculation of the J-integral fracture toughness. The magnitude of fracture toughness was found to be 1.52 ± 0.03 kJ/m2, showing good consistency with the results measured according to the standard analytical formulations. A numerical model of the single edge notch bending specimen was built to compute the local strain field around the crack tip, together with the fracture toughness parameter. Good agreement was confirmed for both the experimental J-integral fracture toughness and the local surface strains around the crack-tip from the digital image correlation based optical technique, compared to the results obtained by numerical simulation. The fracture surfaces of the samples were examined using an optical microscope to analyze the failed surface morphology and the corresponding failure mechanisms.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
