Dimensional accuracy of dental casts: Influence of tray material, impression material, and time

Abstract

This study evaluated the influence on dimensional accuracy of dental casts made with different types of trays and impression materials and poured at different and multiple times. Two types of stock trays (plastic stock tray, perforated metal stock tray) and 4 types of custom tray materials (autopolymerizing acrylic resin, thermoplastic resin, and 2 types of light-polymerized acrylic resins) were used with 2 types of impression materials (addition polymerizing silicone and polyether), to make impressions of a metal master model. Each tray and impression material was used to make 5 impressions. Casts were made by multiple pourings at 30 minutes, 6 hours, 24 hours, and 30 days after impression making. Using a measuring microscope, 12 distances were calculated based on measurements of 8 reference points. The absolute value of the difference of each measurement was calculated, as was the corresponding measurement on the master model. A Bayesian model using a simple noninformative prior was used to analyze these data. Statistical differences within 6 microm were found only with thermoplastic resin tray material for addition silicone, and for thermoplastic resin tray material and 1 type of light-polymerized acrylic resin for polyether. Neither stock trays nor custom trays contributed to the differences in accuracy of the casts. All deviations in casts made with silicone impression material were within a clinically acceptable range. For the polyether, distortions occurred that were clinically unacceptable. Impressions made from polyether distorted over time. Silicone impression material has dimensional stability up to 30 days. Accurate casts can be made with either stock trays or custom trays. An impression made from polyether should be poured only once and within 24 hours after impression making, because of the distortion of the material over time. Silicone impression material has better dimensional stability than polyether. .