Abstract

The objective of the present article is to demonstrate the digital workflow used to manufacture an adjusted oral splint in a patient case. A 25-year-old female patient presented for management of her bruxism. Therefore, an adjusted oral splint was manufactured. A computer-aided motion analysis of the patient was conducted (JMA Optic). Full-arch scans of the maxilla and mandible, a biocopy of the maxilla with a bite fork, and buccal scans of the centric jaw relation (Primescan) were performed. The jaw relation was determined beforehand by ballistic closing on a chairside-fabricated anterior jig. The digital construction of a Michigan splint took place in the dental laboratory. The design was nested and milled from a polymethyl methacrylate (PMMA)-containing blank (CLEARsplint Disc). The oral splint was inserted into the patient's mouth and checked to ensure a tension-free fit. The static and dynamic contact relationship was checked. During the follow-up visit, the patient reported an improvement in tension in the masticatory muscles. The described procedure allows for the manufacture of an adjusted oral splint through a purely digital workflow.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.