Differences in protein content and foaming properties of cloudy beers based on wheat malt content

Abstract

Listen

Translate article

To investigate differences in protein content, all barley malt beer, wheat/barley malt beer and all wheat malt beer were brewed, and the protein during mashing, wort, fermentation and beer determined. It was shown that protein was mainly extracted during mashing and the protein rest phase, decreased in the early stages of fermentation and remained almost steady during wort boiling and cooling, in the middle and late stages of fermentation. By separating beer foam from beer, similar protein bands of 51.7, 40.0, 27.3, 14.8, 6.5 and < 6.5 kDa appeared in the three beers, defoamed beers and beer foams using the sodium dodecyl sulphate polyacrylamide gel electrophoresis. Quantitatively, protein bands of 6.5–14.8 and <6.5 kDa had the highest contents in the three beers. Unique bands at 34, 29.2, 23.0, 19.7 and 17.7 kDa were found in beer, defoamed beer and beer foam from wheat beer and all-wheat malt beer, respectively. Wheat beer foam showed the best foam stability and the protein in all barley malt beer showed the best migration to the foam. The beer foam properties were influenced by not only protein content but also protein characteristics and/or origin. It is suggested that the barley malt contributed the beer foam ‘skeleton protein’ while protein components from wheat malt kept the foam stable. © 2018 The Institute of Brewing & Distilling