Differences in native T1 and native T2 mapping between patients on hemodialysis and control subjects

Abstract

PurposeMyocardial native T1 is a potential measure of myocardial fibrosis, but concerns remain over the potential influence of myocardial edema to increased native T1 signal in subjects prone to fluid overload. This study describes differences in native T2 (typically raised in states of myocardial edema) and native T1 times in patients on hemodialysis by comparing native T1 and native T2 times between subjects on hemodialysis to an asymptomatic control group. Reproducibility of these sequences was tested. MethodsSubjects were recruited prospectively and underwent 3 T-cardiac MRI with acquisition of native T1 and native T2 maps. Between group differences in native T1 and T2 maps were assessed using one-way ANOVAs. 30 subjects underwent test-retest scans within a week of their original scan to define sequence reproducibility. Results261 subjects completed the study (hemodialysis n = 124, control n = 137). Native T1 times were significantly increased in subjects on hemodialysis compared to control subjects (1259 ms ± 51 vs 1212 ms ± 37, p < 0.01). There was no difference in native T2 times between subjects on hemodialysis and control subjects (39.5 ms ± 2.5 vs 39.5 ms ± 2.3, p = 0.9). These differences were unchanged after adjustment for relevant baseline differences (age, sex and hemoglobin). Inter-study reproducibility for native T1 and T2 mapping was excellent (coefficient of variability 0.9 % and 2.6 % respectively). ConclusionsThe increased native T1 signal demonstrated in subjects on hemodialysis occurs independently of differences in native T2 and the two parameters are not orthogonal. Elevated native T1 in patients on hemodialysis may be driven by water related to myocardial fibrosis rather than edema from volume overload.