Abstract
This work is devoted to the study of the interelectrode gap’s condition during wire electrical discharge machining. The experiments were carried out on workpieces made of chromium-nickel anti-corrosion steel 12Kh18N10T and duralumin D16 with a brass tool CuZn35 with a diameter of 0.25 mm in deionized water. The developed diagnostic tool based on vibroacoustic emission recorded oscillations with a frequency of 4 … 8 kHz accompanying the processing.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
