Abstract
The current research focuses on developing nano-crystalline nickel coating for engineering applications through pulse plating technique. Based on the literature survey, the current density, duty cycle and frequency were identified as important grain refining parameters. Coating was done over a mild steel sample after mechanical polishing, vapour degreasing and anodizing. Experiments were conducted using the three determining parameters and their influence on the properties of the coating was evaluated. Coatings were then characterized for the surface morphology and hardness. The XRD analysis for the surface morphology resulted in the grain size of 19 nm and the hardness measured from the microhardness tester was 677 HV which is higher than the hardness reported in the available literatures. The influence of the pulse plating parameters on the grain size and hardness of the coating has been listed out for the benefit of the scientific community.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.