Development of low-cost and personalized external silicone breast prosthesis produced by additive manufacturing for women who have undergone mastectomy: A pilot study

Abstract

BackgroundThe aim of this study was to develop a low-cost and personalized method for external breast prosthesis production. MethodsThe projected light method was used for the acquisition of the 3D geometry of the left breast of a healthy 29-year-old woman, 69 kg and 1.69 m. The 3D modeling software Blender was used to make the prosthesis model and mold with adjustments to the model's mesh, such as smoothing, assigning thickness, and creating the walls of the prosthesis mold. Two counter-molds were created. The pieces were manufactured on the 3D printer Stella Lite 3 using polylactic acid filament. Finally, the silicone was pigmented, and the mold was filled. FindingsPrototype 1 of the prosthesis was produced using a mold without a counter-mold, which resulted in a prosthesis of 495 g, considered heavy compared to traditional prostheses for the same breast size. To solve this issue, a counter-mold with pins was used to produce prototype 2 with a mass of 393 g, 20.6% lighter than prototype 1. Prototype 3 was made with a central-volume counter-mold and presented a mass of 355 g, a reduction of 28.3% compared to prototype 1. The definitive breast prosthesis was made with the pin counter-mold with a different silicone. It has nipple and areola pigmentation and a mass of 294 g, 25.2% lighter than prototype 2. InterpretationThe results suggest that the projected light method and additive manufacturing are potential tools for developing external breast prostheses, which may improve the health conditions and quality of life of mastectomized women.