Abstract
We have developed a new type of superconducting interference device (SQUID) microscope. A direct-coupled SQUID magnetometer with a high-μ metal needle was used and the substrate was machined to create a dimple for the needle at the centre of the pick-up loop. One end of the needle penetrated through the superconducting pick-up loop in a vacuum; the needle was fixed in the vacuum window with the other end at room temperature in the outside atmosphere. Several kinds of simulation using a Maxwell simulator were performed and the results were applied to our system. As a demonstration, a laser-printed output was scanned by the microscope. Line bars with a line width of 100 μm and a spacing between lines of 200 μm were clearly imaged.This paper was presented at the 8th International Superconductive Electronics Conference, Osaka, Japan, 19–22 June 2001.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.