Development of Generalized Porosity-Permeability Transforms by Hydraulic Units for Carbonate Oil Reservoirs in Saudi Arabia

Abstract

Listen

Translate article

Abstract There are several types of porosity-permeability transforms to determine permeability from well log-derived porosity in uncored oil and gas wells. Widely used typical transforms, either by geologic zones or by facies, do not provide satisfactory permeability to be distributed in reservoir simulation models. Hydraulic Unit (HU), which is a technique of rock typing of reservoir, provides far superior transforms than typical transforms. In this work, available routine core data, from major carbonate oil reservoirs located in eight different oil fields of the Kingdom of Saudi Arabia, are assembled to develop improved generalized porosity-permeability transforms by Hydraulic Units (HU). Improved transforms by HUs were developed for major carbonate oil reservoirs in eight different oil fields. Correlation accuracy (R2) of each transform by HU was very good (>0.9). Then all data from eight different fields were combined to develop generalized transforms by HU technique. This technique provided excellent transforms for various HUs regardless of rock fabrics—either limestone or dolomite. Developed generalized transforms by HUs were tested for their accuracies on acquired core data in two wells, completed in the same major carbonate reservoir, but in two different oil fields. Applicability of generalized transforms was also tested with the core data from a different secondary carbonate reservoir. Calculated permeability by HUs matched very well with the tested core data which enhanced the reliability of developed generalized transforms. Similarly, generalized vertical permeability transforms by HUs were developed for the same major carbonate reservoirs in eight fields. Calculated vertical permeability by HUs matched very well with core data as well. Then vertical to horizontal permeability ratios (kV/kH) by HUs were calculated using both generalized transforms for vertical and horizontal permeability. The kV/kH ratios for most of the HUs are found to be almost one under the laboratory condition.