Abstract
A comparative analysis of hot pressing and extrusion for obtaining polymer composite materials based on UHMWPE was carried out. The paper describes physical-mechanical and tribological studies of the developed composite materials. It was found that samples obtained by extrusion have high wear resistance and significantly better deformation and strength properties compared to samples obtained by hot pressing. On the basis of the performed studies, the possibility of processing composites based on UHMWPE by extrusion by adding a low-viscosity grade of PE and stearic acid has been shown.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.