Abstract
A method for passivating the surface of Cd1−xZnxTe (CZT) x-ray and gamma ray detectors using relatively simple dry processing techniques has been developed. Leakage currents were significantly reduced for several processing methods. CZT samples were exposed to an oxygen plasma and/or coated with a reactively sputtered silicon nitride layer. Several parameters of the oxygen plasma step were found to be important for achieving enhanced surface resistivity. SiNX has been previously characterized and was used because of its high dielectric quality and low deposition temperature. Reduction in leakage current after passivation by a factor of as much as twenty is demonstrated. Results are also presented which give a measure of the long-term stability of the passivating layers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
