Development of a physics-based model to predict the performance of pumps as turbines

Abstract

This paper presents the development of a physics-based simulation model, aimed at predicting the performance curves of pumps as turbines (PATs) based on the performance curves of the respective pump. The simulation model implements the equations to be used for the estimation of head, power and efficiency for both direct and reverse operation. Model tuning on a given machine is performed by using loss coefficients and specific parameters identified by means of an optimization procedure, which is first applied to the considered pumps and subsequently to the same machine running in PAT mode.The simulation model is calibrated on data taken from literature, reporting both pump and PAT performance curves for head, power and efficiency over the entire range of operation. The performance data were acquired experimentally from four different centrifugal pumps, running in both pump and PAT mode and characterized by specific speed values in the range of 1.53–5.82. The accuracy of the predictions of the physics-based simulation model is quantitatively assessed against both pump and PAT experimental performance curves. Prediction consistency from a physical point of view is also evaluated.The results presented in this paper highlight that all the performance curves predicted by the simulation model are physically consistent over the entire range of operation. In general, the prediction error on the head of PATs is acceptable, while the accuracy of the prediction of PAT power, and thus of PAT efficiency, is more case-sensitive and usually higher. The relative deviation of model prediction with respect to the field data regarding head and power at the PAT best efficiency point always seems acceptable compared to the uncertainty of the original experimental data and to typical deviations of other methods available in literature.As a conclusion, the physics-based simulation model developed in this paper represents a powerful and reliable tool for estimating PAT performance curves over the entire range of operation based on pump characteristics.