Abstract
HTS synchronous generators, in which the rotor coils are wound from high-Tc superconducting wire, are exciting attention due to their potential to deliver very high torque and power densities. However, injection of the large DC currents required by the HTS rotor coils presents a technical challenge. In this paper we discuss the development of a brushless HTS exciter which operates across the cryostat wall to inject a superconducting DC current into the rotor coil circuit. This approach fundamentally alters the thermal load upon the cryogenic system by removing the need for thermally inefficient normal-conducting current leads. We report results from an experimental laboratory device and show that it operates as a constant voltage source with an effective internal resistance. We then discuss the design of a prototype HTS-PM exciter based on our experimental device, and describe its integration with a demonstration HTS generator. This 200 RPM, 10 kW synchronous generator comprises eight double pancake HTS rotor coils which are operated at 30 K, and are energised to 1.5 T field through the injection of 85 A per pole. We show how this excitation can be achieved using an HTS-PM exciter consisting of 12 stator poles of 12 mm YBCO coated-conductor wire and an external permanent magnet rotor. We demonstrate that such an exciter can excite the rotor windings of this generator without forming a thermal-bridge across the cryostat wall. Finally, we provide estimates of the thermal load imposed by our prototype HTS-PM exciter on the rotor cryostat. We show that duty cycle operation of the device ensures that this heat load can be minimised, and that it is substantially lower than that of equivalently-rated conventional current leads.
Highlights
We show how this excitation can be achieved using an high temperature superconducting (HTS)-permanent magnets (PMs) exciter consisting of 12 stator poles of 12 mm YBCO coated-conductor wire and an external permanent magnet rotor
In this paper we present a novel design for a rotating flux pump exciter which is capable of injecting currents across a cryostat wall, enabling the direct excitation of an HTS rotor coil circuit
We report on the performance of an experimental prototype device and discuss the integration of this device as a novel brushless exciter for an 8-pole, 10 kW, synchronous HTS generator
Summary
An additional problem for the design of synchronous HTS machines is the transfer of large DC currents across a rotating joint, in order to excite the HTS rotor coils Existing excitation technologies such as slip-rings [20] and high-frequency brushless-exciters [21, 22] all reduce performance and increase cost and complexity. Inductive brushless-exciters [25] require high-stability switched-mode power electronics to be mounted upon the rotor if large DC currents are to be injected This is generally unsuitable for high-speed operation, and can reduce the machine’s overall power density, reliability and ease of maintenance. We report on the performance of an experimental prototype device and discuss the integration of this device as a novel brushless exciter for an 8-pole, 10 kW, synchronous HTS generator
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
