DEVELOPMENT OF A 150 W LINEAR LABORATORY POWER SUPPLY UNIT

Abstract

The laboratory power supply is an indispensable device for the manufacture, testing, adjustment and repair of electronic equipment. The object of research is the process of selecting and justifying the device circuit on a modern element base, developing a printed circuit board, manufacturing and testing the created device layout in practice. The toroidal transformer of the required power was also calculated. The test was carried out in the voltage and current stabilization mode, and the data obtained indicate the possibility of further improvement of the device's circuitry. To build a laboratory power supply, it is desirable to use a linear circuit, because of the small pulsations that are critical when powering electronic equipment. A switching power supply can be used as an additional source when working with high-power circuits. A universal option is a bipolar power supply built according to a linear circuit with an output voltage of 0...±30 V and a current of 0...5 A. This solution will allow the device to be used for operation with most radio electronic devices, including those sensitive to RF noise, whose power consumption does not exceed 150 W. Thanks to the use of a bipolar circuit, it is also possible to work with high-quality audio frequency amplifiers that require bipolar power supply, operational amplifiers and some digital equipment. The galvanic isolation of the channels will make it possible to adjust the output parameters independently for each arm, which may be necessary when repairing digital equipment. Equipping the laboratory power supply with a current stabilization unit will make it possible to use the power supply as a battery charger and help in finding short circuits in circuits. Short-circuit protection will save the power supply in the event of an emergency and, in some cases, save the connected load.