Developing a geomechanical model to predict breakdown pressure in a vertical borehole using failure analysis: a case study

Abstract

Breakdown is an important process in geomechanics; a very complex process in hydraulic fracturing which has been the subject of extensive research in the literature. There exist several models in the literature for predicting the breakdown pressure. In this research, the breakdown pressure for hydraulic fracturing in a vertical borehole was modeled using 2D and 3D failure analysis. In the geomechanical model constructed in this case study, elastic moduli were obtained using petrophysical data as well as data extracted from core analysis. The in-situ stress state of the reservoir was obtained by poroelastic horizontal strain model and was then validated by field data. To test the accuracy of the horizontal strain model, several models were used to obtain the minimum horizontals stress. At the end, the induced principal stresses inside the borehole were modeled by Kirch Equations. Four failure criteria, namely Mohr–Coulomb, 2D Hoek–Brown, Hubbert-Willis and 3D Mogi-Coulomb were used to obtain the breakdown pressure for the target reservoir. Based on the prediction results of these failure criteria, it was obtained that 2D Hoek–Brown, Hubbert-Willis, and 3D Mogi-Coulomb criteria resulted in seemingly unrealistic breakdown pressures with respect to the minimum horizontal stress gradient. The Mohr–Coulomb criterion produced lower breakdown pressure gradients, yet closer to the minimum horizontal stress values, even though it neglects the effect of intermediate stress.