Detonation Soot: A New Class of Ice Nucleating Particle

Abstract

AbstractTemperatures and pressures from high explosive detonations far exceed atmospheric conditions in typical combustion reactions, and consequently, detonation soot forms with physiochemical properties distinct from soot formed by combustion. In this study, samples of detonation soot from two high explosives, PBX 9502 and Composition B‐3, were analyzed. Ice nucleation experiments on soot collected after controlled detonations were conducted in the laboratory to probe immersion and contact mode freezing. Samples nucleated ice at temperatures warmer than commercially available nanodiamonds, which has a mean nucleation temperature of −20.7°C. Ice nucleation rate coefficients increase rapidly by two to three orders of magnitude below −20°C for every sample. Size‐selected 137 μm diameter particles produced during detonation in an ambient air atmosphere yield bimodal distributions of freezing temperature with primary and secondary nucleation modes centered at −20°C and −13°C, respectively. The presence of a secondary mode allows for enhanced ice nucleation rate coefficients (one to two orders of magnitude greater than samples without a secondary mode) at temperatures outside the influence of the primary mode (>−17°C). Given the observed onset nucleation temperatures of −9.2°C, our results imply that detonation soot of the type studied here would only need to reach an altitude of approximately 4 km to facilitate ice formation.