Abstract
The aim of this study is to determine the warpage in injection molded parts with amorphous structure and to compare the experimental results with simulation results. A numerical simulation using commercial software (moldflow) to obtain a warped part through temperature difference between injection mold plates were done. The coupons were obtained through injection molding, manipulating the temperature difference between mold plates through cooling system temperatures. It was observed that the temperatures difference between plates is a major factor regarding warpage, while as great is the temperature difference, greater is the warpage. It was observed that the part warps towards the hottest plate and there is a systematic difference between experimental results and simulation results, as seen in the literature. Key words: injection molding, warpage, residual stress.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
