Abstract
The reactivity transient following a control rod step strongly depends on quantities that determine the thermal reactivity feedback. For the special case of a pressurized water reactor, these quantities are the reactivity temperature coefficients and the heat transfer between fuel and coolant. Therefore, it is possible to determine these quantities by fitting appropriate model calculations to measured reactivity transients. This so-called rod step method was extensively applied for the first time in the first cycle of the nuclear power plant KCB at Borssele in the Netherlands. The values of the heat transfer between fuel and coolant and those of the fuel temperature coefficient that are obtained by this method agree well with the theoretically expected behavior with increasing core burnup.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have