Determination of the inelastic mean free path of electrons in GaAs and InP after surface cleaning by ion bombardment using elastic peak electron spectroscopy

Abstract

Abstract The inelastic mean free path (IMFP) of electrons is an important material parameter needed for quantitative AES, EELS and non-destructive depth profiling. The distinction between the terms for IMFP and the attenuation length (AL) has been established by ASTM standards. A practical experimental method for determining values of the IMFP is elastic peak electron spectroscopy (EPES). In this method, experimentally determined ratios of elastically backscattered electrons from test surfaces and from a Ni reference standard are compared with the values evaluated theoretically. The present paper reports systematic measurements of the IMFP by EPES for GaAs and InP. They are carried out in two laboratories using two different electron spectrometers: a CMA in Budapest and DCMA in Warsaw. Prior to measurements, the samples were amorphized by high-energy Ar + ions (100–400 keV), and the surface composition was determined by quantitative XPS. Argon cleaning produces enrichment of samples in the surface layer in Ga (80%) and In (70%), respectively. The experiments refer to a such modified sample surface that was considered in Monte Carlo calculations. The experimental data were analyzed using calibration curves from Monte Carlo calculations which account for multiple elastic scattering events. This approach has been used previously for elemental solids and is now extended to amorphized binary compounds. The experimental values of IMFP obtained in both laboratories exhibited a reasonable agreement with the available literature data in the 0.1–3.0 keV energy range. With respect to the information depth of EPES, the experimental results refer to the bulk composition within a reasonable extent.