Abstract
An ac surface photovoltage method was applied in order to estimate the fixed oxide charge density in naturally oxidized n-type Si wafers. Three n-type Si wafers (100-mm diameter, 540-µm thick and a resistivity of 1.1 mΩ·m) were used after forming 2.4-nm oxide layers on their surfaces as the result of an alkaline rinse treatment. The ac surface photovoltages in the frequency range of 1 Hz to 10 kHz were analyzed using the half-sided junction model previously reported. The photon energy of the probing beam was 2.23 eV. The surface potential, fixed oxide charge and interface trap densities were determined to be –0.38 V, –0.93 mC·m-2 and 5×1015m-2·eV-1, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.