Abstract
A series of bromine-containing flame-retardant plastics was used to demonstrate the applicability of pulsed radio frequency glow discharge mass spectrometry to the determination of elements in commercial polymers. The direct analysis of bulk samples produced both atomic and molecular species, allowing elemental identification and molecular characterization. However, the low ion signal intensities hindered quantification. Atomization mechanisms for the plastic samples were studied in detail using scanning electron microscopy and mass spectrometry. Although some thermal desorption was observed, sputter atomization dominated when samples were not subjected to excessive discharge power. The sputter rates of various polymers, as evidenced by sputter weight loss measurements, showed a strong correlation with their ion production capabilities. Sputtering rates were related to the physical and chemical properties inherent to a polymer's composition. Analysis of samples compacted with a silver binder provided intense analyte signals allowing quantitative analysis. Signal stability, measurement accuracy, measurement precision, and detection limits were all assessed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
