Abstract
This work presents the design of a membrane distillation (MD) unit coupled to a refrigeration device. The operation of an MD pilot plant is first tested then simulated using EES solver. The range of hot water feed temperature provided by the condenser of the refrigeration device may vary from 25 to 65°C as needed by the MD unit. The results of the experimental study enable to validate a 1D theoretical model with a maximum deviation of ±6%. This model is combined to a heat pump model to simulate the operation of a coupled machine.The system performance is studied following two scenarios. In Scenario 1 (continuous mode), the system is connected to a seawater network. In Scenario 2 (batch mode), the seawater reservoir is filled up manually every day. The simulation study shows that the increase of the feed water temperature enhances significantly the produced permeate flux but decreases the performance of the heat pump. This system exhibits high exergy efficiency and GOR for a high feed water temperature. Exergy efficiency and gained output ratio (GOR) decrease as the water flow increases and the hot water temperature decreases. Conversely, the coefficient of performance (COP) of the refrigerator increases.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
