Design, preparation and electromechanical characteristics analysis of piezoelectric 1-3-type composites with sandwich polymer structures

Abstract

Aiming at the shortcomings of the traditional 200 kHz 1–3 piezoelectric composites with a thickness of 7.5 mm, which have a lower electromechanical coupling coefficient, lower resolution and larger acoustic impedance, a piezoelectric 1–3-type composites with sandwich polymer structures with higher electromechanical coupling coefficient and lower acoustic impedance was designed in this paper. First, the piezoelectric composites with different volume fractions of piezoelectric ceramics and silicone rubber were simulated by COMSOL software, and the optimal volume fractions of piezoelectric ceramics and silicone rubber were obtained. Second, the first and second lateral mode frequencies of the piezoelectric 1–3-type composites with sandwich polymer structures with different kerf widths were calculated. Then, based on the electromechanical equivalent circuit, the electromechanical characteristics of the piezoelectric 1–3-type composites with sandwich polymer structures were analyzed, and the equivalent performance parameters of the piezoelectric composite were obtained. Compared with other 7.5 mm thickness 1–3 piezoelectric composites, it was found that the electromechanical coupling coefficient of the piezoelectric 1–3-type composites with sandwich polymer structures is significantly increased, and the acoustic impedance is significantly decreased. Therefore, the piezoelectric 1–3-type composites with sandwich polymer structures has great potential advantages in the preparation of high-performance piezoelectric ultrasonic transducers.