Design of wireless in-pipe inspection robot for image acquisition

Abstract

PurposePipeline robots are often used in pipeline non-destructive testing. Given the need for long-range in-pipe inspections, this study aims to develop a wireless in-pipe inspection robot for image acquisition.Design/methodology/approachIn this paper, an in-pipe robot with a new mechanical system is proposed. This system combines a three-arm load-bearing structure with spring sleeves and a half-umbrella diametric change structure, which can ensure the stability of the camera when acquiring images while maintaining the robot’s flexibility. In addition, data were transmitted wirelessly via a system that uses a 433 MHz ultra-high frequency and wireless local-area network–based image transmission system. Software and practical tests were conducted to verify the robot’s design. A preliminary examination of the robot’s cruising range was also conducted.FindingsThe feasibility of the robot was demonstrated using CATIA V5 and MSC ADAMS software. The simulation results showed that the centre of mass of the robot remained in a stable position and that it could function in a simulated pipeline network. In the practical test, the prototype functioned stably, correctly executed remote instructions and transmitted in near real-time its location, battery voltage and the captured images. Additionally, the tests demonstrated that the robot could successfully pass through the bends in a 200-mm-wide pipe at any angle between 0° and 90°. In actual wireless network conditions, the electrical system functioned for 44.7 consecutive minutes.Originality/valueA wheeled wireless robot adopts a new mechanical system. For inspections of plastic pipelines, the robot can adapt to pipes with diameters of 150–210 mm and has the potential for practical applications.