Abstract

Brushless DC motors have been applied extensively in household and industrial scale because of the advantages such as high efficiency and mechanical losses are low because it does not use the brush like a DC motor. Application of the brushless DC motors using 220 rms AC source is rectified to minimize battery usage. However, the use of brushless DC motors and rectifying circuit can cause poor power factor and harmonic value. Power factor value reaches 0,73 while the current THD at 74%. These values are outside the permitted tolerance limits. This study aims to improve the power factor and THD value of current caused by the operation of brushless DC motors using a SEPIC converter. Moreover, the purpose of this study is that the motor is able to operate at different levels of speed and load vary. Based on the results of the simulation from the design has been made, the motor can respond to variations in the speed reference given to well. The control circuit is also able to make the motor maintain its speed with changes in the load every time. Power factor observed in resources has increased to 0.999 at various speeds. In addition, the current THD has an average value of 2% at various speeds. Both of these parameters are within the tolerances allowed by the standard.

Highlights

  • Abstrak— Motor brushless DC sudah diaplikasikan secara luas pada skala rumah tangga maupun industri karena kelebihan yang dimiliki seperti efisiensi tinggi dan rugi-rugi mekanik yang rendah karena tidak menggunakan brush seperti motor DC

  • Mode operasi Single Ended Primary Inductor Converter (SEPIC) ketika switch off Ketika switch dalam keadaan off, arus pada akan dialirkan ke dan, menuju dan beban. dan akan terisi kembali dan akan men-charge ketika switch kembali on

  • Mode operasi SEPIC ketika switch on Ketika switch dalam keadaan on, energi yang disimpan pada kapasitor input akan disalurkan ke sementara energi pada kapasitor intermediat akan disalurkan ke

Read more

Summary

PENDAHULUAN

MOTOR brushless DC sering digunakan untuk aplikasi rumah tangga maupun industri karena memiliki rasio torsi/inersia dan efisiensi yang tinggi. Sumber motor brushless DC adalah dengan menggunakan baterai. Sumber yang digunakan untuk pengoperasian motor brushless DC adalah sumber AC 220 volt karena lebih murah dan praktis. Pada motor brushless DC konvensional yang menggunakan sumber AC 220 volt, drive hanya berupa rectifier (penyearah) dan kapasitor DC link. PWM yang digunakan untuk mengatur kecepatan menyebabkan terjadinya losses pada switch VSI dikarenakan frekuensi switching yang tinggi. Tujuan dari penelitian ini adalah merancang drive brushless DC menggunakan Single Ended Primary Inductor Converter (SEPIC) dengan respon kecepatan yang baik dan memiliki performansi kualitas daya yang tinggi. Kontrol kecepatan yang didesain diharapkan bisa dijadikan acuan untuk penerapan secara langsung pada motor brushless DC dengan spesfikasi yang telah ditentukan

Motor Brushless DC
Teknik Kontrol Kecepatan dan PFC
Konfigurasi Kontrol Kecepatan Berbasis Power Factor
Hasil Pengujian Pada Kecepatan Bervariasi dan Beban Bervariasi
Perbandingan Nilai PF dan THD Arus pada Metode
KESIMPULAN
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call