Abstract
This paper describes the design of current mode instrumentation amplifier (CMIA) for portable biosignal acquisition system. The CMIA topology is based on voltage mode operational amplifier (op amp) power supply current sensing technique. Op amp mismatch and precise current mirrors are two design challenges of this topology. A simulation analysis is conducted based on an implementation in a CMOS 0.35 µm technology. The CMIA consumes 20.22 µW under a 3 V DC power supply and has a continuous adjustable gain bandwidth product (GBW)-independent voltage gain via single resistor. The CMRR is higher than 120dB up to 1 Hz and more than 80 dB up to 100 Hz.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.