Design of Collagen-Based Hemostatic Material for Use in Plastic and Reconstructive Surgery

Abstract

This study aims to develop collagen-based hemostatic materials. The sheet-shaped collagen sponge was manufactured by freeze-vacuum drying the aqueous solution of collagen (Col) and heat-denatured collagen (Col’) at a composition ratio of 2/1. The both sides or one side of sponge was treated with ultraviolet (UV) irradiation for 15 minutes to introduce intermolecular crosslinks between collagen molecules. The elution behavior of collagen sponge was investigated by immersing the sponge in water for a predetermined time and then by measuring the weight change. The double-sided UV-irradiated sponge showed very slow elution properties. On the other hand, the single-sided UV-irradiated sponge showed initially fast elution and subsequent very slow elution properties. Such initially fast elution of collagen molecules from the surface without UV-irradiation allows an adhesion of collagen sponge to the wound surface and results in hemostatic effect. In addition, the water absorption and retention properties of sponge were investigated by placing the hydrated sponge on a mesh for a predetermined time and then by measuring the weight change. The double-sided UV-irradiated sponge absorbed 81 times more water than own weight and showed a value of 45 times even after 7 days. The single-sided UV-irradiated sponge absorbed 80 times more water than own weight and showed a value of 39 times even after 7 days. The sponge with high water absorption and retention properties allows a wound healing effect because such sponge can absorb large amounts of blood plasma and exudates containing various cell growth factors. The double-sided UV-irradiated sponge is a good candidate for the wound dressing. On the other hand, the single-sided UV-irradiated sponge is a good candidate for the hemostatic material.