Abstract
An antenna that works at high frequencies, specifically in the microwave region, is called an MPA, which stands for "Microstrip Patch Antenna." MPA is appropriate for electronic and wireless communication devices operating on 4G and 5G. This research presents the design and fabrication of a 1X2 and 1X4 circular form MPA-Array for a 5G wireless communication system. It is possible to get three distinct resonant frequencies of 4.5GHz, 5.4GHz, and 6.4GHz, with a value of gain 7.22dBi and a bandwidth of 2012MHz. The concept uses a cutting-edge layout for a patch antenna with a circular form and a partial ground. The Printed Circuit Board (PCB) constructed of copper with two sides is used to create the hardware design. An FR-4 epoxy substrate is used to fabricate the MPA-A, which is then put through an experimental test where its findings are compared to those generated by a simulation
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Emerging Technology and Advanced Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.