Design consideration for design a flat and ring plastics part using Solidworks software

Abstract

Various considerations on design of plastic injection moulded parts were applied in initial stage to prevent any defects of end products. Therefore, the objective of this project is to design the plastic injection moulded part by taking consideration on several factors such as draft angle, corner radius and location of gate. In this project, flat plastic part, ring plastic part, core inserts for flat and ring plastic part were designed using SolidWorks software. The plastic part was drawn in sketching mode then the 3D modeling of solid part was generated using various commands. Considerations of plastic part such as draft angle and corner radius with location of gate was considered in the design stage. Finally, it was successfully designed the two plastic parts with their respectively insert by using SolidWorks software. The flat plastic part and ring plastic part were designed for the purpose for future researches for study the weld lines, meld lines, air trapped and geometrical size of the product. Thus, by designing the flat plastic part and ring plastic part having core insert on each part, the completed mould design of two plate mould can be considered. This is because, plastic injection parts are needed to be designed properly in order to neglect any defect when the mould was made.