Abstract
The article introduces a design and analysis results of a prototype ORC (organic Rankine cycle) turbo generator rotor assembly of 300kW power, supported by tilting-pad bearings of original design. The calculations were performed for a prototype turbo generator rotor. The shaft of this machine is supported with two radial bearings, lubricated with an unusual lubricant – a low-boiling-point agent. The main objective of the presented research was to perform calculations verifying the feasibility of using hydrodynamic tilting-pad radial bearings with a low-viscosity lubricant to support a rather massive and high-speed rotor of the developed turbo generator and to determine the geometry and design of the bearings which would ensure optimal kinetostatic and dynamic properties of the rotating system, while simultaneously providing ease of assembly and smooth clearance adjustment.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
