Abstract
A device for converting the energy of mechanical vibrations to electricity by the piezoelectric effect is presented. A main part of the transducer is a multilayer cantilever with the inertial mass at the tip. A piezoelectric layer is made of 0.5 μm thick aluminum nitride. A feature of the device is the compact lateral size of about 1 mm, which is 10 times smaller in comparison with conventional harvesters. The device is fully compatible with microelectromechanical systems (MEMS) technology. The cantilever has a natural frequency of 45-160 Hz, depending on the size and inertial mass. The transducer generates the output voltage of 0.35 V, which is high enough for rectifying by the diode bridge. The output power of 2.7 nW is relatively low due to the small size. Nevertheless, the figure of merit is higher than that for conventional AlN-based energy harvesters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
